THE BEST INSPIRATION

Underfloor-heating-floor-sensor-resistance, to ensure that your floor heating system will function properly, always test the resistance of your wires with a digital multimeter set to 200 ohms before, during and after installation.. What is the resistance of the floor sensor circuit for the aube th232 underfloor heating thermostat?, it is important to test your electric underfloor heating three times; before you start the installation, after you’ve finished laying the system and again after you’ve laid the floor finish. this ensures that any damage caused to the heating cable during installation is detected and can be dealt with. there are 2 tests to perform – […].

3 meter floor temperature sensor probe for underfloor heating thermostat features works with a wide range of different thermostats. please check the resistance values of your current sensor against the table, replacement floor temperature sensor suitable for a wide range of underfloor heating thermostats. works with a wide range of different thermostatsplease check the resistance values of your current sensor against the table below for compatibility 3 metre long cable cable has high rigidity, allowing it to be easily passed through existing flexible conduit suitable for use in wet areas. ip68 .... The floor sensor should be placed centre of two wire runs at least 300mm into the heated area. it is important that the floor sensor is fitted in the correct location in order to read an accurate floor temperature.